Secure Hitch Mount Installation

Secure Hitch Mount easily mounts to any vehicle, any surface, any location with 4 self drilling screws that when the hitch slider is on the SecureHitchMount the mounting screws are tamper proof once the combination lock is in place.

Contents

Tools Required

(1) Secure Hitch Mount

Drill with 1/4” nut driver bit

(4) #8 x ¾” Self-drilling screws

Pencil/Marker

(1) Hitch Pin Clip

 

(1) Combination Master Lock

 

 

Vehicle Install Instructions

  1. Slide SecureHitchMount onto your Hitch Ball Mount Slider.
  2. Hold the assembly up in desired location & mark edge of SecureHitchMount on surface to be mounted.
  3. Remove SecureHitchMount from your Hitch Ball Slider.
  4. Hold SecureHitchMount up to mark on surface to be mounted and mark holes.
  5. Using a drill with a 1/4” nut driver bit, insert the self-drilling screw into mounting hole, line up with hole marks then drill and secure 1st
  6. Slide your Hitch Ball Slider onto the SecureHitchMount and confirm location and clearance is where desired. Remove from SecureHitchMount careful not to move its position.
  7. Drill and secure the remaining 3 screws into the SecureHitchMount.
  8. Slide Hitch Ball Slider onto SecureHitchMount and use hitch pin clip or Master Lock to secure.
  9. Go put your truck to work!

Master Lock Combo Setting

  1. With dials at 0-0-0, pull out shackle
  2. Turn shackle clockwise 90 degrees (1/4 turn) and press it down
  3. Continue pressing down and turn shackle another 90 degrees clockwise (1/4 turn)
  4. Set dials to your own combination
  5. Turn shackle counterclockwise 90 degrees (1/4 turn) lift and return shackle to original position